Since the steam applied to the garment industry for decades of history. The traditional installation method is required for each steam iron are from the mains connection of the boiler over, and then directly to the Vice-iron pipes of the "tail gas" drain, steam heat can not be fully utilized, resulting in a lot of energy and water waste. At the same time, the steam in the cold reduction in the water is a natural phenomenon of physics, the traditional installation method in the steam cooling through long pipes into water easily. Therefore, some garment enterprises in order to reduce the use of iron in the water, hot iron workers who had to switch to open the end of steam; some garment enterprises in order to ensure steam drying, boiler pressure had increased, but the higher the emissions from the boiler pressure "tail gas" the greater, especially for large apparel manufacturers, pipe diameter, long distance, steam in the cold and more than 45% waste rate. 
 In order to solve the energy waste, steam water problems, with energy-saving steam iron steam iron steam trap installed to drain the whole interface, you can place links release valve, automatic discharge of the iron waste water drained off the water automatically, no Let the steam loss can improve the iron temperature, saving energy, saving time, is a clothing iron is a good helper. . . . Quantity price negotiable. Stainless steel trap a total of 500, promotional price of 38 / month, while supplies last.